|
PARVEEN's Tubing Head Spools(PTHS) body have a straight bore with a 45 deg landing shoulder. While the top flange has hold down screws as standard equipment for securing tubing hanger, the bottom flange is designed for installation PARVEEN's bottom pack -off PBP-1 & PBP-2(PP-seal for high pressure over 5000 PSI) and is provided with bit guide, a plastic packing injection port with bleeder outlet and a test port. This can accept Tubing Hangers Mandrel Type 'PTHSM', Wrap around type 'PTHSW' and extended neck type 'PTHSE'.
Standard outlets are 2 1/16" 2000-10000 PSI W.P studded. Even 2" Line Pipe & Flanged outlets can also be provided. Studded outlets are threaded internally for the valve removal plugs. Top flange is provided with hold down screws to secure tubing hanger.
PTHD Tubing Head Spools are designed for the popular split hanger suspensions for dual completions. It has welded wedges for hanger alignment and an open - face top flange.
Type 'PTHD' Tubing Spool accepts either the 'PTHDE','PTHSCL','PTHDCL' tubing hangers. This tubing spool is provided with a wedge to position the hanger. The standards outlets are 2 1/16 2000-10000 PSI W.P studded. The outlets are threaded for the valve removal plug to allow for the removal of the valve. The bottom of the flange is designed for installing the type PBP-1 Bottom pack off(PP Seal for high pressure over 5000 PSI W.P) and is provided with a plastic packing injection port and a test port. The top of the spool is provided with hold down screws to secure the tubing hanger.
|
|
